Through these processes: ingredients-cutting-grooving-cutting corners-bending-board assembly-reinforcement-re-inspection.
Ingredients: According to the order received by the factory, select the data model, specification, and color, and then transport it to the cutting machine before cutting it.
Cutting: When cutting, first adjust the locator to the required scale. After cutting a small point, check whether the scale matches the required scale. When it does, start cutting, and vice versa, adjust until the fit stops. When cutting, the direction must be precise. From left to right, from top to bottom, backward cutting is prohibited; at the end of the cut, check to see if it meets the specifications, and then place the plate gently in the cleaning channel to stop the plate from being decorated. The face is damaged.
Grooving: When grooving, it should be noted that the processing diagram must be analyzed, confirmed and finalized again.
Angle cutting: punching on the angle punching machine, the angle of cutting is not allowed to exceed the center line of the groove.
Bending: Be careful not to bend repeatedly, and bend twice at most to avoid fatigue damage.
Board assembly and reinforcement: First prepare the materials and things for the board assembly, and pay attention to the process of assembling the board not to damage the surface of the board.
Re-inspection: Perform a re-inspection of the completed aluminum alloy sheet 5052 to see if it meets the manufacturing specifications and prevents bad effects on the manufacturer when it leaves the factory.