6063 Шарҳи алюминийи анодшуда
6063 хӯлаи алюминийи анодшуда аз сабаби истихроҷи он дар саноати сохтмон аз чаҳорчӯбаи тиреза то пулҳо васеъ истифода мешавад., муқовимат ба зангзанӣ ва қувваи кашиш. Қисмҳои аноддорро дар дарҳо ёфтан осон аст, лавозимоти ванна ва, Албатта, сақфҳо, тирезаҳо, ва ороиши дохилию берунии бинохо.
Anodizing Process of 6063 Алюминий
But what is anodized aluminum? In a few words, anodizing is a process used to increase the oxide layer on the surface of aluminum. Баъд, a hard, wear-resistant protective layer is created. Let's explain the process in more detail:
Anodizing is an electrolytic process, яъне. it uses electrical current to produce electrolytic reactions, including anodic oxidation and cathodic reduction. It is at this point that the aluminum anode is almost completely covered by the aluminum oxide film.
During anodization, the thickness of the surface oxide layer increases. Its structure and characteristics can be modified according to the following changes:
- Properties of Electrolytes
- its composition
- its temperature
- Healing period
- voltage used
The process of adnized
6063 VS 6061
Two common variants of 6000 series aluminum alloys are 6061 and 6063.Both of them are widely used, but what is the specific difference?
| Таркиби химиявӣ | In terms of Mg and SI, 6061 аст 30-50% бештар аз 6063. The most direct effect is that 6061 has a greater strengthening effect than 6063. |
| Хусусиятҳои механикӣ | The strengthening effect of 6061 heat treatment is greater. Баракс, the higher the tensile strength, the greater the deformation resistance, so the plasticity of the 6061 alloy is lower than 6063. |
| Plasticity | 6061-T6 is used in occasions that require certain strength and hardness. 6063 is a representative alloy for extrusion with good extrudability. |
| Other Aspects | Табобати рӯизаминӣ: Ҳарду 6061 ва 6063 anodizing properties are very good. 6063 aluminum is better.
Қобилияти коркард: Both are good. 6061 is better. |
In a few words,6061 aluminum offers higher strength and workability than 6063 алюминий, аммо 6063 has better extrudability.
Packaging of 6063 хӯлаи алюминийи anodized
